SE Tool Neo / Arc Test Point Cable - TestPoint MT15/LT15i

[andrelino]

SE Tool Neo / Arc Test Point Cable - TestPoint MT15/LT15i

*Color of product may be different from the one shown in our website depending on stock availability. However this does not effect the function of the cable in any way.

• + SE Tool Neo / Arc Test Point Cable

Test Point Cable Description:
It is additional cable to use with latest update from producer of SeTool box that allows to unlock Arc (LT15i) or Neo (MT15) by Test Point. Full instruction about cable use you can find on producer forum.

How To Use :

1. Make sure you have firmware with android 2.x, NOT 1.6. Firmware 2.3 is NOT supported, downgrade to 2.1. Flash required firmware, if needed.
2. Power on phone without sim card, go to menu -> settings -> applications -> development, enable "usb debugging". Connect phone to PC, install drivers from setool2 distr (driversADB_Drivers)
3. Select proper phone model.
   • on settings check signed mode, use alternative security bypass, do full unlock instead usercode reset
   • press unlock
   • when prompted, detach phone, turn it on fully, connect it again.
     ( or you can leave phone on cable, then power it on manually )
   • when program tells "warming up...", manually power on phone fully, cause it will automatically enter charging mode.
   • after you see "GETTING ROOT ACCESS ..." DO NOT TOUCH PHONE until procedure complete.

DO NOT DETACH PHONE FROM CABLE AFTER PROCEDURE STARTED, YOU CAN KILL
YOUR PHONE, ONLY RIFF JTAG WILL HELP.

DO NOT REMOVE BATTERY FROM PHONE AFTER PROCEDURE STARTED, YOU CAN KILL YOUR PHONE, ONLY RIFF JTAG WILL HELP

Possible problems:

you getting "err: 00000005","err: 00000002" during process.

solution:
disable antivirus, especially if you using "koshmarsky antivirus", i recommend Doctor Web
do NOT run setool2 from restricted accounts.
do NOT run setool2 from read-only media.

problem:
it can happen ( very unlikely, though ) that ADB server will not recognize phone after reboot

solution:
IF phone not detecting automatically and on status bar you can see "waiting for phone...", again - only in that case - disconnect phone from usb and connect it again, procedure should continue.

if not, well, repeat from start.


How to unlock s1 android based phones using alternative security bypass using testpoint?

1. Prepare for testpoint operation. Check testpoint location for your phone model in distdocsOpen testpoint for access. Get some needle with wire, connect it to phone gnd ( battery minus ) or to usb cable shield, etc.
2. Select proper phone model. On settings check signed mode, use alternative security bypass, do full unlock instead usercode reset/ fill login/password and check if account valid. Press unlock

When prompted, execute steps in EXACT order:

• Remove cable from phone,
• Remove battery from phone,
• Attach testpoint
• Press "ready"
• Insert cable to phone, HOLDING TESTPOINT
• Install drivers from distdriversUSBFlash_driver
• When prompted detach testpoint
• Press "ready"

Cabo usado:


TestPoint:


Onde comprar?
[Somente usuários registrados podem ver os links. Clica aqui para se registrar...]